HP 6125G Configuration Manual page 45

Configuration procedure
Configure an IP address for each interface. (Details not shown.)
1.
Configure basic RIP functions:
2.
# Enable RIP 100 and specify RIP version 2 on Switch A.
<SwitchA> system-view
[SwitchA] rip 100
[SwitchA-rip-100] network 10.0.0.0
[SwitchA-rip-100] network 11.0.0.0
[SwitchA-rip-100] version 2
[SwitchA-rip-100] undo summary
[SwitchA-rip-100] quit
# Enable RIP 100 and RIP 200 and specify RIP version 2 on Switch B.
<SwitchB> system-view
[SwitchB] rip 100
[SwitchB-rip-100] network 11.0.0.0
[SwitchB-rip-100] version 2
[SwitchB-rip-100] undo summary
[SwitchB-rip-100] quit
[SwitchB] rip 200
[SwitchB-rip-200] network 12.0.0.0
[SwitchB-rip-200] version 2
[SwitchB-rip-200] undo summary
[SwitchB-rip-200] quit
# Enable RIP 200 and specify RIP version 2 on Switch C.
<SwitchC> system-view
[SwitchC] rip 200
[SwitchC-rip-200] network 12.0.0.0
[SwitchC-rip-200] network 16.0.0.0
[SwitchC-rip-200] version 2
[SwitchC-rip-200] undo summary
[SwitchC-rip-200] quit
# Display the routing table of Switch C.
[SwitchC] display ip routing-table
Routing Tables: Public
Destination/Mask
12.3.1.0/24
12.3.1.2/32
16.4.1.0/24
16.4.1.1/32
127.0.0.0/8
127.0.0.1/32
Configure route redistribution:
3.
# On Switch B, configure RIP 200 to redistribute direct routes and routes from RIP 100.
[SwitchB] rip 200
[SwitchB-rip-200] import-route rip 100
Destinations : 6
Proto Pre
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Routes : 6
Cost NextHop
0 12.3.1.2
0 127.0.0.1
0 16.4.1.1
0 127.0.0.1
0 127.0.0.1
0 127.0.0.1
35
Interface
Vlan200
InLoop0
Vlan400
InLoop0
InLoop0
InLoop0