Configuring Bfd For Ospf - HP 6125G Configuration Manual

[SwitchA] display ip routing-table
Routing Tables: Public
Destination/Mask
3.1.1.0/24
3.1.2.0/24
10.1.1.0/24
10.1.1.1/32
10.2.1.0/24
10.2.1.1/32
10.3.1.0/24
10.4.1.0/24
127.0.0.0/8
127.0.0.1/32
The route destined for 10.5.1.1/24 is filtered out.

Configuring BFD for OSPF

Network requirements
As shown in
other at the network layer.
After the link over which Switch A and Switch B communicate through a Layer 2 switch fails, BFD can
quickly detect the failure and notify OSPF of the failure. Switch A and Switch B then communicate through
Switch C.
Figure 42 Network diagram
Device
Switch A
Switch C
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Destinations : 10
Proto
O_ASE
O_ASE
Direct 0
Direct 0
Direct 0
Direct 0
OSPF
OSPF
Direct 0
Direct 0
Figure 42, OSPF is enabled on Switch A, Switch B and Switch C that are reachable to each
Interface IP address
Vlan-int10 10.1.0.102/24
Vlan-int11 11.1.1.1/24
Vlan-int11 11.1.1.2/24
Vlan-int13 13.1.1.2/24
Routes : 10
Pre Cost NextHop
150 1 10.2.1.2
150 1 10.2.1.2
0 10.1.1.1
0 127.0.0.1
0 10.2.1.1
0 127.0.0.1
10 4 10.1.1.2
10 13 10.2.1.2
0 127.0.0.1
0 127.0.0.1
Device
Switch B
113
Interface
Vlan200
Vlan200
Vlan100
InLoop0
Vlan200
InLoop0
Vlan100
Vlan200
InLoop0
InLoop0
Interface IP address
Vlan-int10 10.1.0.100/24
Vlan-int13 13.1.1.1/24