HP 6125G Configuration Manual page 291

Step
1. Enter system view.
2. Create an OSPF process
for a VPN instance and
enter OSPF view.
3. Disable routing loop
detection.
4. Configure the OSPF
domain ID.
5. Redistribute the VPN
routes.
6. Configure a filtering policy
to filter advertised routes.
7. Configure the default
parameters for
redistributed routes (cost,
route number, tag, and
type).
8. Create an OSPF area and
enter OSPF area view.
9. Enable OSPF on the
interface attached to the
specified network in the
area.
Configuring EBGP between MCE and PE
Step
1. Enter system view.
2. Enter BGP view.
3. Enter BGP-VPN instance
view.
4. Configure the PE as the
EBGP peer.
5. Redistribute the VPN
routes of the VPN site.
Command
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
vpn-instance-capability simple
domain-id domain-id [ secondary ]
import-route protocol [ process-id |
allow-ibgp ] [ cost cost | type type |
tag tag | route-policy
route-policy-name ] *
filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ protocol
[ process-id ] ]
default { cost cost | limit limit | tag
tag | type type } *
area area-id
network ip-address wildcard-mask
Command
system-view
bgp as-number
ipv4-family vpn-instance vpn-instance-name
peer { group-name | ip-address } as-number
as-number
import-route protocol [ process-id |
all-processes ] [ med med-value |
route-policy route-policy-name ] *
281
Remarks
N/A
N/A
Disabled by default.
You must disable routing loop
detection for a VPN OSPF process on
the MCE. Otherwise, the MCE
cannot receive OSPF routes from the
PE.
Optional.
0 by default.
By default, no route of any other
routing protocol is redistributed into
OSPF.
Optional.
By default, advertised routes are not
filtered.
Optional.
The default cost is 1, the default
maximum number of routes
redistributed per time is 1000, the
default tag is 1, and default type of
redistributed routes is Type-2.
By default, no OSPF area is created.
By default, an interface neither
belongs to any area nor runs OSPF.
Remarks
N/A
N/A
N/A
N/A
By default, no route
redistribution is configured.