HP 6125G Configuration Manual page 200

Figure 71 Network diagram
Configuration procedure
Configure the IPv6 addresses for all VLAN interfaces. (Details not shown.)
1.
Configure IPv6 static routes:
2.
# Enable IPv6 and configure a default IPv6 static route on Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ipv6 route-static :: 0 4::2
# Enable IPv6 and configure two IPv6 static routes on Switch B.
<SwitchB> system-view
[SwitchB] ipv6
[SwitchB] ipv6 route-static 1:: 64 4::1
[SwitchB] ipv6 route-static 3:: 64 5::1
# Enable IPv6 and configure a default IPv6 static route on Switch C.
<SwitchC> system-view
[SwitchC] ipv6
[SwitchC] ipv6 route-static :: 0 5::2
Configure the IPv6 addresses for all the hosts based on the network diagram, configure the default
3.
gateway of Host A, Host B, and Host C as 1::1, 2::1, and 3::1.
Verify the configuration:
4.
# Display the IPv6 routing table on Switch A.
[SwitchA] display ipv6 routing-table
Routing Table :
Destination
NextHop
Interface
Destination
NextHop
Interface
Destinations : 5
: ::
: 4::2
: Vlan200
: ::1/128
: ::1
: InLoop0
Routes : 5
Cost
190
Protocol : Static
Preference : 60
: 0
Protocol : Direct
Preference : 0
Cost : 0