Rip Operation; Rip Versions; Rip Message Format - HP 6125G Configuration Manual

Split horizon—Disables RIP from sending routing information on the interface from which the
•
information was learned to prevent routing loops and save bandwidth.
Poison reverse—Enables RIP to set the metric of routes received from a neighbor to 16 and sends
•
back these routes to the neighbor so the neighbor can delete such information from its routing table.
Triggered updates—RIP immediately advertises triggered updates for topology changes to reduce
•
the possibility of routing loops and to speed up network convergence.

RIP operation

RIP works as follows:
RIP sends request messages to neighboring routers. Neighboring routers return response
1.
messages containing their routing tables.
RIP uses the received responses to update its local routing table and sends triggered update
2.
messages to its neighbors. All RIP routers on the network do this to learn latest routing information.
RIP periodically sends the local routing table to its neighbors. After a RIP neighbor receives the
3.
message, it updates its routing table, selects optimal routes, and sends an update to other
neighbors. RIP ages routes to keep only valid routes.

RIP versions

There are two RIP versions, RIPv1 and RIPv2.
RIPv1 is a classful routing protocol. It advertises messages through broadcast only. RIPv1 messages do
not carry mask information, so RIPv1 can only recognize natural networks such as Class A, B, and C. For
this reason, RIPv1 does not support discontiguous subnets.
RIPv2 is a classless routing protocol. It has the following advantages over RIPv1:
Supports route tags to implement flexible route control through routing policies.
•
• Supports masks, route summarization, and Classless Inter-Domain Routing (CIDR).
Supports designated next hops to select the best ones on broadcast networks.
•
Supports multicasting route updates so only RIPv2 routers can receive these updates to reduce
•
resource consumption.
Supports simple authentication and MD5 authentication to enhance security.
•
NOTE:
RIPv2 supports two transmission modes: broadcast and multicast. Multicast is the default mode using
224.0.0.9 as the multicast address. An interface operating in RIPv2 broadcast mode can also receive
RIPv1 messages.

RIP message format

A RIP message consists of a header and up to 25 route entries. (A RIPv2 authentication message uses the
first route entry as the authentication entry, leaving 24 available.)
18