HP 6125G Configuration Manual page 179

BGP Local router ID is 1.1.1.1
Status codes: * - valid, ^ - VPNv4 best, > - best, d - damped,
Network
*> 8.1.1.0/24
*> 9.1.1.0/24
*
The output shows two valid routes to destination 9.1.1.0/24: the route with next hop 3.1.1.1 is
marked with a greater-than sign (>), indicating it is the best route (because the ID of Switch B
is smaller); the route with next hop 3.1.2.1 is marked with only an asterisk (*), indicating it is a
valid route, but not the best.
By using the display ip routing-table command, you can find only one route to 9.1.1.0/24 with
next hop 3.1.1.1 and outbound interface VLAN-interface 200.
On Switch A, configure the number of ECMP routes destined for AS 65009 to improve link
3.
utilization.
# Configure Switch A.
[SwitchA] bgp 65008
[SwitchA-bgp] balance 2
[SwitchA-bgp] quit
Verify the configuration:
4.
# Display the BGP routing table on Switch A.
[SwitchA] display bgp routing-table
Total Number of Routes: 3
BGP Local router ID is 1.1.1.1
Status codes: * - valid, ^ - VPNv4 best, > - best, d - damped,
Network
*> 8.1.1.0/24
*> 9.1.1.0/24
*>
The route 9.1.1.0/24 has two next hops 3.1.1.1 and 3.1.2.1, both of which are marked with a
greater-than sign (>), indicating they are the best routes.
By using the display ip routing-table command, you can find two routes to 9.1.1.0/24: one with
next hop 3.1.1.1 and outbound interface VLAN-interface 200, the other with next hop 3.1.2.1
and outbound interface VLAN-interface 300.
h - history, i - internal, s - suppressed, S - Stale
Origin : i - IGP, e - EGP, ? – incomplete
NextHop
0.0.0.0
3.1.1.1
3.1.2.1
h - history, i - internal, s - suppressed, S - Stale
Origin : i - IGP, e - EGP, ? - incomplete
NextHop
0.0.0.0
3.1.1.1
3.1.2.1
169
MED LocPrf
0
0
0
MED LocPrf
0
0
0
PrefVal Path/Ogn
0 i
0 65009i
0 65009i
PrefVal Path/Ogn
0 i
0 65009i
0 65009i