Configuring A Priority For Ripng; Configuring Ripng Route Redistribution; Tuning And Optimizing The Ripng Network; Configuring Ripng Timers - HP 6125G Configuration Manual

Step
4. Configure a filter policy to
filter outgoing routes.

Configuring a priority for RIPng

Any routing protocol has its own protocol priority used for optimal route selection. You can set a priority
for RIPng manually. The smaller the value, the higher the priority.
To configure a RIPng priority:
Step
1. Enter system view.
2. Enter RIPng view.
3. Configure a RIPng priority.

Configuring RIPng route redistribution

Step
1. Enter system view.
2. Enter RIPng view.
3. Configure a default routing
metric for redistributed routes.
4. Redistribute routes from
another routing protocol.

Tuning and optimizing the RIPng network

This section describes how to tune and optimize the performance of the RIPng network, as well as
applications under special network environments. Before tuning and optimizing the RIPng network,
complete the following tasks:
Configure a network layer address for each interface.
•
Configure the basic RIPng functions.
•

Configuring RIPng timers

Adjust RIPng timers to optimize the performance of the RIPng network. When adjusting RIPng timers,
consider the network performance, and perform unified configurations on routers running RIPng to avoid
unnecessary network traffic increase or route oscillation.
Command
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ protocol [ process-id ] ]
Command
system-view
ripng [ process-id ]
preference [ route-policy
route-policy-name ] preference
Command
system-view
ripng [ process-id ]
default cost cost
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
197
Remarks
By default, RIPng does not filter
outgoing routing information.
Remarks
N/A
N/A
Optional.
By default, the RIPng priority is
100.
Remarks
N/A
N/A
Optional.
The default metric of redistributed
routes is 0.
By default, no route redistribution
is configured.