Injecting A Local Ipv6 Route; Configuring A Preferred Value For Routes From A Peer Or Peer Group - HP 6125G Configuration Manual

Step
1. Enter system view.
2. Enter BGP view.
3. Specify a router ID.
4. Enter IPv6 address family
view.
5. Specify an IPv6 peer.

Injecting a local IPv6 route

Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 address family
view.
4. Inject a local route into the
IPv6 BGP routing table.
Configuring a preferred value for routes from a peer or peer
group
If you both reference a routing policy and use the command peer { ipv6-group-name | ipv6-address }
preferred-value value to set a preferred value for routes from a peer, the routing policy sets the specific
preferred value for routes matching it. If the preferred value in the routing policy is zero, the routes use the
value set with the peer { ipv6-group-name | ipv6-address } preferred-value value command. For how to
use a routing policy to set a preferred value, see the command peer { group-name | ipv4-address |
ipv6-address } route-policy route-policy-name { import | export } in this chapter, and the command
apply preferred-value preferred-value in Layer 3—IP Routing Command Reference.
To configure a preferred value for routes from a peer or peer group:
Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 address family
view.
4. Configure a preferred value
for routes received from an
IPv6 peer or peer group.
Command
system-view
bgp as-number
router-id router-id
ipv6-family
peer ipv6-address as-number
as-number
Command
system-view
bgp as-number
ipv6-family
network ipv6-address prefix-length
[ short-cut | route-policy
route-policy-name ]
Command
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address } preferred-value
value
231
Remarks
N/A
N/A
Optional.
Required if no IP addresses are
configured for any interfaces.
N/A
N/A
Remarks
N/A
N/A
N/A
Not added by default.
Remarks
N/A
N/A
N/A
By default, the preferred value is 0.