Configuring An Ipv6 Bgp Route Reflector - HP 6125G Configuration Manual

Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 address family
view.
4. Advertise COMMUNITY
attribute to an IPv6 peer or
peer group.
5. Advertise extended
community attribute to an IPv6
peer or peer group.
Applying a routing policy to routes advertised to a peer or peer group
Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 address family
view.
4. Apply a routing policy to
routes advertised to an IPv6
peer or peer group.

Configuring an IPv6 BGP route reflector

Follow these guidelines when you configure an IPv6 BGP route reflector:
Because the route reflector forwards routing information between clients, you must make clients of a route
reflector fully meshed. If clients are fully meshed, HP recommends disabling route reflection between
clients to reduce routing costs.
If a cluster has multiple route reflectors, you must specify the same cluster ID for these route reflectors to
avoid routing loops.
To configure an IPv6 BGP route reflector:
Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 address family
view.
4. Configure the router as a route
reflector and specify an IPv6
peer or peer group as a client.
5. Enable route reflection
between clients.
Command
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address }
advertise-community
peer { ipv6-group-name |
ipv6-address }
advertise-ext-community
Command
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name export
Command
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address } reflect-client
reflect between-clients
246
Remarks
N/A
N/A
N/A
Not advertised by default.
Not advertised by default.
Remarks
N/A
N/A
N/A
Not applied by default.
Remarks
N/A
N/A
N/A
Not configured by default.
Optional.
Enabled by default.