Configuring Ripng Route Summarization; Advertising A Default Route; Configuring A Ripng Route Filtering Policy - HP 6125G Configuration Manual

Step
1. Enter system view.
2. Enter interface view.
3. Specify an inbound routing
additional metric.
4. Specify an outbound
routing additional metric.

Configuring RIPng route summarization

Step
1. Enter system view.
2. Enter interface view.
3. Advertise a summary IPv6
prefix.

Advertising a default route

With this feature enabled, a default route is advertised through the specified interface regardless of
whether the default route is available in the local IPv6 routing table.
To advertise a default route:
Step
1. Enter system view.
2. Enter interface view.
3. Advertise a default route.

Configuring a RIPng route filtering policy

Reference a configured IPv6 ACL or prefix list to filter received or advertised routing information. You can
also filter outbound routes redistributed from a routing specific routing protocol.
To configure a RIPng route filtering policy:
Step
1. Enter system view.
2. Enter RIPng view.
3. Configure a filter policy to
filter incoming routes.
Command
system-view
interface interface-type interface-number
ripng metricin value
ripng metricout value
Command
system-view
interface interface-type interface-number
ripng summary-address ipv6-address prefix-length
Command
system-view
interface interface-type
interface-number
ripng default-route { only |
originate } [ cost cost ]
Command
system-view
ripng [ process-id ]
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
import
196
Remarks
N/A
N/A
Optional.
0 by default.
Optional.
1 by default.
Remarks
N/A
N/A
Not advertised by default.
Remarks
N/A
N/A
By default, RIPng does not filter
incoming routing information.