YASKAWA VS-626M5 Instruction Manual page 98

Fig. 5.1 shows the display section and operation keys of the Digital Operator, and Fig. 5.2 shows the LED dis-
play status of the RUN and STOP keys. Table 5.1 shows the displayed characters and the corresponding alpha-
bets and numbers, and Fig. 5.3 shows the display of bit selection signal.
Run Command Key
These are run command keys when the drive is oper-
ated by the Digital Operator. These keys are effective
only in operation by Digital Operator.
DRIVE/PRGM: Emergency stop
When this key is depressed, the op-
eration speed is reduced and stopped.
Then current is interrupted.
JOG: Jog run:
When this key is held down, jogging
is possible.
FWD/REV: Forward and reverse rotation switch
When this key is depressed, direction
of rotation is changed.
RUN: Run command
When RUN is depressed, the red LED on
the left part of the key lights.
STOP: Stop command
When STOP is depressed, the red LED on
the left part of the key lights.
Fig 5.1
RUN and STOP LEDs light, blink, and go OFF depending on the status of operation.
FWD
REV
RUN
JOG
Fig 5.2
DRIVE FWD REV REMOTE
DRIVE FWD REV
REMOTE
SEQ
SEQ
Digital Operator
JVOP-132
LOCAL DRIVE
REMOTE
PRGM
JOG
ENTER
FWD
REV
RUN STOP
JOG
Display Unit and Operation Keys of the Digital Operator
Motor Speed
[FWD]or [REV]
Speed Reference
RESET
Main Circuit Power Supply
STOP
LED Display of RUN and STOP Keys
5 -3
5.1 Function of the Digital Operator
Mode Display LED
Digital Operator Running Indication
Lights in the Digital Operator operation mode.
Rotation Direction Indication
FWD: Lights when forward run command is
input.
REV: Lights when reverse run command is
input.
Remote Mode Indication
SEQ: Lights when the motor rotates in the re-
verse direction.
REF: — — —
REF
REF
Display
Displays monitored values of speed reference
and function set values.
Display Selection Key
Depress this key to select display items.
Read/Write Key
DSPL
Depress this key to display set values of
constants. Depress this key again to write
DATA
set values.
Numeral Change Key
Use these keys to change values such as set
RESET
values and constant Nos.
∧: Increment key
∨: Decrement key
Digit Selection Key
Use this key to select a position in a set val-
ue to be changed. The selected position
blinks. (Use this key to reset after and error
occurs.)
RUN
LED
STOP
LED
ON Blink
5
OFF