YASKAWA VS-626M5 Instruction Manual page 260

Specifications
14.3.5 Digital Operator and Connector Cables
DRIVE FWD REV
DIGITAL OPERATOR
JVOP-132
DRIVE
LOCAL
REMOTE PRGM
JOG
FWD
REV
14
RUN
70(2.76)
Mounting Method 1
J
As shown in the following diagram, the Digital Operator can be fixed easily just by drilling holes in the
panel on the side to be mounted, and fixing the Digital Operator using screws from the back of the panel.
(Screws must be supplied by the customer. If the panel thickness is 1.6 mm, use Sems screws M3 x 8.)
Panel cutout
(Viewed from the front of the panel.)
REMOTE
SEQ
REF
DSPL
DATA
ENTER
RESET
STOP
Fig 14.21 Mounting the Digital Operator to a Panel, Method 1 (Unit: mm)
Mounting Method 2
J
Use this method to mount the Digital Operator from the back of the panel using a metal plate.
As shown in the following diagram, this method supports the Digital Operator using a metal plate from
the back of the panel by drilling screw holes making a cutout in the panel.
The code number for the metal plate is DACT32183-AD.
Panel cutout
(Viewed from the front of the panel.)
Panel
cutout
6 0
(2.36)
Fig 14.22 Mounting the Digital Operator to the Panel, Method 2 (Unit: mm)
4 (0.16)
Panel cutout
(for cable)
Panel front
8 6
(0.31) (0.24)
2-φ4 hole
27
4
(1.06)
(0.16)
70(2.76)
Panel surface
2-φ4.8 hole
14 -56
Mounted on the panel
Panel
Cable clamp (Mount the Digital
Operator to the panel before
mounting the cable.)
Panel back
18.8
(0.74)
30 min.
Mounted on the panel
Metal plate
Cable clamp
Panel front
50 min.
Panel back