Wol Enable Jumper - Gateway 7250R System Manual

The following table shows the settings required to let you update the BMC
firmware. Make sure you turn off the server and unplug the power cord before
moving the jumper.
Mode
Normal
Update BMC
Caution

WOL Enable jumper

The WOL Enable jumper on the system board (jumper J5A2) lets you enable
the wake-on-LAN feature. (See the figure on page 6 for the location of the
jumper.)
The following table shows the settings required to perform this task. Make
sure you turn off the server and unplug the power cord before moving the
jumper.
Mode
Disabled
Enabled
Caution
Jumper
Setting
Pins 9-10
Pins 10-11
Moving the jumper while the power is on can damage the
server. Always turn off the server and unplug the power
cord before moving the jumper.
Jumper
Setting
Pins 1-2
Pins 2-3
Moving the jumper while the power is on can damage the
server. Always turn off the server and unplug the power
cord before moving the jumper.
Action When Set
Normal boot (default)
System updates BMC
Action When Set
Disables wake-on-LAN
Enables wake-on-LAN (default)
Setting the system board jumpers
73