Replacing The Fans - Gateway 7250R System Manual

6
Place the replacement board in the chassis in the same orientation as the
original board, then replace the four screws you removed in Step 5.
7
Reconnect the cables to the board at the same locations and in the same
orientations as they were originally connected.
8
Replace the power supply.
9
Close the case. (See "Closing the case" on page 20.)
10
Reconnect the power cord and external peripherals, then turn on the
system.

Replacing the fans

The fans are located between the system board and the hot plug drive cage.
The fans are not hot-plug capable and you must shut down the system to
replace a fan.
To replace a fan:
1
Turn off the system and disconnect the power cord and external
peripherals.
2
Open the case. (See "Opening the case" on page 18 and "Preventing static
electricity discharge" on page 17.)
3
Unplug the fan cables from the system board.
54
Replacing and Adding Internal Devices