Modem Problems - Gateway 7250R System Manual

Probable cause
A memory chip is faulty
The system does not recognize a new or second processor
Probable cause
The processor was installed
incorrectly
The processor speed was not
set correctly in the BIOS Setup
utility
The system only detected one
processor

Modem problems

The system does not recognize the modem
Probable cause
The modem has not been
added as new hardware
The modem is not connected
to a live phone jack
The phone jack is shared by
another modem or telephone
The modem is not configured
with a valid interrupt or
address
90
Troubleshooting
Solution
Replace the card with the faulty chip. Third-party
diagnostic programs can help determine which chip or
memory segment is failing.
Solution
Check the installation. Make sure that the processor
is fully seated in its socket. The processor should be
recognized automatically if it was installed correctly.
If the server BIOS lets you select the processor
speed, make sure that you have selected the proper
speed.
Enable the processor retest in the BIOS Setup utility.
Solution
Add the modem as new hardware.
Make sure that the line connected to the modem is
working and plugged into the appropriate port on the
modem (line port).
If the modem shares the jack with another device, make
sure that the other device does not have the port open.
Check the system settings for possible conflicts. If one
exists, correct the problem by selecting an available
interrupt and address.