Error Messages - Gateway 7250R System Manual

Probable cause
The display setup is incorrect
The video card has failed
The video is distorted
Probable cause
The monitor controls are
not properly adjusted
The connector or cable is
damaged
The surge protector or
UPS is damaged
The monitor is too close
to a source of electrical
interference
The monitor needs to be
degaussed

Error messages

This section lists common error messages that you may see. These messages
often indicate procedural errors such as an incorrect keystroke or a
write-protected diskette. Some messages, however, may indicate a problem
that requires you to consult the troubleshooting section of this manual.
Error message
Access denied
Solution
In the Control Panel window (Start | Settings | Control
Panel), double-click Display and check the settings.
The correct video type should be selected, along with
a supported resolution. Check your monitor and video
controller documentation for details.
Try another video card.
Solution
Adjust the monitor controls until the text becomes clear. (See
your monitor documentation for more information.)
Check the connector and cable for bent or damaged pins.
Disconnect the monitor power cable, then connect it directly
to the power source.
Move the monitor away from sources of electrical
interference, such as televisions, unshielded speakers,
microwave ovens, fluorescent lights, and metal beams or
shelves.
Turn off the server and monitor and leave them off for at least
a half hour, then restart the system.
Solutions
Try saving to a new file or diskette.
Move the write-protection tab over the hole on the back of
the diskette.
Error messages
97