Memory; Replacing Memory - Gateway 7250R System Manual

Memory

Four DIMM sockets on the system board support up to 2.0 Gigabytes (GB) of
PC/100 SDRAM.

Replacing memory

The DRAM DIMMs supported by the system board conform to the following
standards:
128 MB, 256 MB, and 512 MB ECC DIMMs
PC/100-compliant, unbuffered, ECC SDRAM
128 MB minimum system memory
2.0 GB maximum system memory
When you select and install DIMMs, keep the following in mind:
Registered DIMMs should not be combined with unbuffered DIMMs
Memory should be added in order, from DIMM 1 to DIMM 4.
There can be no empty slots between installed DIMMs.
No jumper settings are required for the memory size or type because the
BIOS automatically detects this information.
To replace DIMMs:
1
Turn off the system and disconnect the power cord and all other external
peripheral devices.
2
Open the case. (See "Opening the case" on page 18 and "Preventing static
electricity discharge" on page 17.)
33
Memory