Advertisement
Resolved Caveats for Cisco IOS Release 12.2(44)SQ2
Caveat
CSCsx07352
CSCsx24142
CSCsy01867
CSCsy14112
CSCsy33389
CSCsy78520
OL-18677-10
Description
Symptoms: During a system boot up, it takes about 4 minutes for AAA server to
allow a console login after the first "Press RETURN to get started" message is
displayed at the prompt. During this period, the box displays "% Authentication
failed." message after the return key is pressed.
Conditions: This issue occurs when the following conditions are configured:
AAA accounting
•
AAA authentication
•
Workaround: Disable AAA accounting configuration.
Symptoms: De-configured "snmp trap link-status" reappears after chassis reloads
or hw-module reset command is executed.
Conditions: This issue occurs after de-configuring "snmp trap link-status", saving
the running configuration and then reloading the chassis or using the hw-module
reset command.
Workaround: There is no workaround.
Symptoms: SNMP and system messages about internal Gigabit Ethernet interfaces
or loopback interfaces are displayed. These messages should not been seen by the
user.
Conditions: The messages are displayed during a system boot up.
Workaround: There is no workaround.
Symptoms: During a Cisco RFGW-10 DS-48 line card failover and switchback, a
spike in the noise floor is seen in the RF spectrum. The noise floor lasts about half
a second.
Conditions: The RF noise shows up on the line card switchback after a failover.
This problem also shows up if a port is configured with all parameters kept in mute
state. When the port is moved from mute to unmute state, the noise is seen in the
spectrum.
Workaround: There is no workaround.
Symptoms: The Cisco RFGW-10 DS-48 line card switchover from a primary card
to the secondary card results in high-level RF noise floor.
Conditions: This issue may happen when the QAM channel power is set to a higher
level (> 51 dBmV) and line card switchover is performed. It depends on the RF
frequency and the slot ID of the primary line card.
Workaround: Lower the RF power setting on primary line cards.
Symptoms: NULL packets in Annex B QAM 64/256 cause higher RF noise floor.
Conditions: This happens when the data traffic in RF channel is idle.
Workaround: There is no workaround.
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
Caveats
49
Advertisement
