Advertisement
Caveats
Caveat
CSCud65515
CSCud14476
CSCud00035
CSCul07567
CSCul24808
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
22
Description
Symptoms: Primary DEPI session do not go to the up state for some
QAM channels on the Cisco RFGW-10.
Conditions: This issue occurs when invalid RF power range exists
for the QAM channels causing loss of DEPI sessions on the QAM
channel.
Workaround: Deconfigure and configure the DEPI tunnel for the
QAM channel. This should bring up the DEPI sessions.
Symptoms: Modems come to the online state instead of w-online
state after the primary line card is reset or switched over.
Conditions: This issue occurs when the following conditions exist:
No physical connection exists between the secondary line card
•
and the CMTS
Revertive time is set in the redundancy configuration
•
Workaround: There is no workaround.
Symptoms: Traceback and error messages are observed on the Cisco
RFGW-10 router after line card revertback.
Conditions: This issue occurred after a line card revertback was
performed using redundancy linecard group switchover slot
command.
Workaround: There is no workaround.
Symptom: Hike in CPU utilisation observed while verifying the
midplane ping after removing a line card route.
Condition: This occurs when the following steps are done:
Reset the line card and wait till it is in ready state
•
Remove the line card route
•
Workaround: Add the removed line card route.
Symptom: Greatwhite IU failure is observed on Cisco RF Gateway
10 (RFGW-10) DS-48 line card.
Condition: This occurs when Cisco RF Gateway 10 (RFGW-10)
DS-48 line card boots up, and heartbeat failure is seen.
Workaround: The RFGW-10 recovers automatically and no
workaround is required.
OL-18677-10
Advertisement
