Advertisement
Caveat
CSCud51870
CSCud65515
Resolved Caveats for Cisco IOS Release 12.2(50)SQ5
Caveat
CSCsl58384
CSCsy92331
OL-18677-10
Description
Symptoms: Previous configurations of the line card (prior to configuring
redundancy) are still preserved after the line card is removed from the redundancy
group. DEPI sessions are not cleared.
Conditions: This issue occurs when the primary line card is removed from a
redundancy group and configured as a secondary in a new redundancy group, and
again removed from the new redundancy group and added back into the previous
redundancy group as a primary line card.
Workaround: Before configuring any line card as a secondary line card, default all
QAM ports of the line card to be configured as secondary. Issue the default
interface Qam command to default the interfaces.
or
Manually remove all the configuration for that line card.
Symptoms: Primary DEPI session do not go to the up state for some QAM
channels on the Cisco RFGW-10.
Conditions: This issue occurs when invalid RF power range exists for the QAM
channels causing loss of DEPI sessions on the QAM channel.
Workaround: Deconfigure and configure the DEPI tunnel for the QAM channel.
This should bring up the DEPI sessions.
Description
Symptoms: The Cisco RFGW-10 router crashes due to Layer2 traffic getting
punted to SP (switch processor).
Conditions: This issue occurs when port-security feature is enabled and rate
traffic of high (more than 4k) value of scaled MAC addresses is sent.
Workaround: Rate-limit the Layer2 data using mls rate-limit layer2
port-security 5000 command.
Symptoms: Memory leaks and fragmentation are observed when exceptions are
encountered.
Conditions: This issue occurs when SNMP queries lead to exceptions causing
memory leaks.
Workaround: There is no workaround.
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
Caveats
31
Advertisement
