Caveats
Caveat
CSCui48322
CSCuh47212
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
24
Description
Symptom: The physical parameters in the QAM
DB that are learnt from the CMTS in case of
remote learn, are not defaulted or cleared.
!
interface Qam11/8.1
cable downstream rf-shutdown
cable downstream frequency 483000000
<<<<<<<< Cable DS frequency is learnt from
CMTS.
!
Conditions: The following configurations are
required:
Configure remote learn sessions using cable
•
mode command
•
Change the QAM interface settings to default
settings
Workaround: Set the interface to default twice to:
–
first clear mode, tsid and tunnel
configurations, except the physical
parameters configuration
second time, set all the physical
–
parameters to default
OR
Before defaulting the QAM interface, remove the
remote learn mode, then set the QAM interface
to default.
Symptom: Unused DEPI CP protect tunnels are
not deleted. The error message occurs:
ueq01(config)#no depi-tunnel cts01_protect1
% depi-tunnel:cts01_protect1 is in use and
cannot be deleted
Conditions: Enter depi tunnel mode and do the
following:
–
Remove the existing protect tunnel
–
Configure a new protect tunnel
Exit.
–
Workaround: Enter depi tunnel mode and do the
following:
–
directly replace/configure new protect
tunnel. This will delete old tunnel also
–
Exit
OL-18677-10