Advertisement
Caveats
Open Caveats for Cisco IOS Release 12.2(44)SQ
Caveat
CSCsu27160
CSCsv01988
CSCsw23043
CSCsw26480
CSCsw26789
Command RF
Output Power
RF Gateway 10
Cablelabs DRFI
Compliance
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
54
Description
Symptoms: The GUI: HTTP CORE process may take a large percent of Supervisor
CPU at web page refresh.
Conditions: This issue occurs when a GUI web browser page is refreshed.
Workaround: There is no workaround.
Symptoms: The GUI "Summary" page does not display dual Supervisor interfaces
correctly. The GUI does not display information on the "Summary" page in the
SUP Input B/W or SUP Input Measurement sections.
Conditions: This issue occurs when redundant Supervisor cards are configured.
Workaround: There is no workaround.
Symptoms: Resetting one line card causes a momentary glitch on another line card.
Conditions: This issue occurs only when the hw-module slot reset command is
issued.
Workaround: Use the cable linecard reset command to reset a line card.
Symptoms: When un-muting an RF port, the RF power level tends to raises the
noise floor around the RF channels supported momentarily (for several hundreds
of milliseconds). There are no reported issues of cable modem performance, though
the impact is observed on a spectrum analyzer.
Conditions: This issue occurs during muting the RF port output power.
Workaround: There is no workaround.
Symptoms: The "DocsDevEvent" table does not function.
Conditions: When the MIB table is accessed, there is no data returned.
Workaround: There is no workaround.
DRFI requires support for a 8 dB range of commanded transmit power per channel
below the maximum power supported for the channel (maximum power - 8 dB).
The Cisco RFGW-10 is tested to a range of 10 dB of commanded power below the
maximum supported channel power.
The Cisco RFGW-10 CLI allows a commanded RF power range 30 dB
Note
lower than maximum supported channel power (maximum power - 30 dB).
However, a commanded power range below 10 dB of maximum power
supported is not calibrated and may not be accurate.
The noise floor and spurious emissions of the Cisco RF Gateway 10 DS-48 line
card do not meet the requirements of the Cablelabs DRFI technical specification.
OL-18677-10
Advertisement
