Advertisement
Caveat
CSCub95597
CSCuc34778,
CSCuc34786
CSCud00035
CSCud01957
CSCud02393
CSCud09247
CSCud14476
OL-18677-10
Description
Symptoms: Issuing snmpwalk command on ifName MIB objects invokes
traceback and crashes the Cisco RFGW-10 router.
Conditions: This issue occurs while issuing snmpwalk command on ifName MIB
object is performed.
Workaround: There is no workaround.
Symptoms: Interprocess communication (IPC) causes the Cisco RFGW-10 to
crash with stack traces.
Conditions: This issue was first observed in Cisco IOS Release 12.2(50)SQ3 and
Cisco IOS Release 12.2(50)SQ4.
Workaround: There is no workaround.
Symptoms: Traceback and error messages are observed on the Cisco RFGW-10
router after line card revertback.
Conditions: This issue occurred after a line card revertback was performed using
redundancy linecard group switchover slot command.
Workaround: There is no workaround.
Symptoms: Traceback and error messages are observed on the Cisco RFGW-10
router while resetting the Cisco RFGW-10 line cards (both primary & secondary)
repeatedly multiple times.
Conditions: This issue occurs when line card redundancy is configured on the
Cisco RFGW-10 router and line card is reset repeatedly using hw-module slot
reset command.
Workaround: There is no workaround.
Symptoms: DEPI midplane pings failed count counter is incremented by 1 or n
even when a DEPI route exists on the Cisco RFGW-10 router.
Conditions: This issue occurs when the Cisco RFGW-10 router is left idle for a
long time. The show midplane ping statistics command displays the failed
counter value incremented by 1 or n.
Workaround: Clear the midplane ping statistics and verify the midplane ping
statistics again.
Symptoms: FastEthernet1 port and VLAN interfaces go to down state after
replacing the saved configuration with a running configuration on the
Cisco RFGW-10 router.
Conditions: This issue occurs when the Cisco RFGW-10 is reloaded and the saved
configuration is replaced with the running configuration.
Workaround: There is no workaround.
Symptoms: Modems come to the online state instead of w-online state after
hw-module reset command is issued on the primary line card.
Conditions: This issue occurs when line card redundancy with revertive time-on
is configured on the Cisco RFGW-10 router and hw-module reset command is
issued on the primary line card.
Workaround: There is no workaround.
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
Caveats
29
Advertisement
