Advertisement
Caveats
Open Caveats for Cisco IOS Release 12.2(50)SQ2
Caveat
CSCtk63045
CSCtk97075
CSCtl00116
Resolved Caveats for Cisco IOS Releases 12.2(50)SQ2
Caveat
CSCth59227
CSCti06671
CSCti96877
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
42
Description
Symptoms: After Supervisor switchover, "No such session" messages are seen in
the newly active Supervisor. This does not affect the performance of the system.
Conditions: This issue occurs when the Supervisor is configured in stateful
switchover (SSO) redundancy mode, the DEPI control plane protocol is in use
instead of DEPI manual, and the Supervisor switchover CLI (redundancy force
switchover) is executed.
Workaround: There is no workaround.
Symptoms: Traceback is observed on the new active Supervisor after Supervisor
switchover. This does not affect the performance of the system.
Conditions: This issue occurs when DEPI control plane is configured, the Cisco
RFGW-10 is in stateful switchover (SSO) mode, and the line card
high-availability is not configured on both the Cisco CMTS and Cisco RFGW-10.
Workaround: There is no workaround.
Symptoms: Secondary line card member is not added.
Conditions: This issue occurs when line card redundancy is configured and the
line card redundancy group ID is not 0 or 1.
Workaround: Use line card redundancy group ID 0 or 1.
Description
Symptoms: The Supervisor HTTP process takes more number of CPU cycles and
leads to CPU utilization spikes.
Conditions: This issue was observed at the 30 second interval while monitoring
the GUI Summary page with DEPI sessions configured on the Cisco RFGW-10.
Workaround: There is no workaround.
Symptoms: The confreg value command that is used for changing the register
configuration on the Cisco CMTS is not supported on the Cisco RFGW-10
Supervisor.
Conditions: When you execute the confreg value command, the following
message is displayed:
usage: confreg
Workaround: There is no workaround.
Symptoms: Approximately 25% to 50% of the cable modems drop offline after
Supervisor switchover.
Conditions: This issue occurs when DEPI control plane is used between the Cisco
CMTS and Cisco RF Gateway 10 with multiple DEPI tunnels in use.
Workaround: Use manual DEPI.
OL-18677-10
Advertisement
