Advertisement
Caveats
Open Caveats for Cisco IOS Release 12.2(50)SQ
Caveat
Command RF
Output Power
Resolved Caveats for Cisco IOS Release 12.2(50)SQ
Caveat
CSCsu27160
CSCsv01988
CSCta60651
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
46
Description
DRFI requires support for an 8-dB range of commanded transmit power per
channel below the maximum power supported for the channel (maximum power is
8 dB). The Cisco RFGW-10 is tested to a range of 10 dB of commanded power
below the maximum supported channel power.
Note
The Cisco RFGW-10 CLI allows a commanded RF power range 30 dB
lower than maximum supported channel power (maximum power - 30 dB).
However, a commanded power range below 10 dB of maximum power
supported is not calibrated and may not be accurate.
Description
Symptoms: The GUI: HTTP CORE process may use a large amount of Supervisor
CPU at web page refresh.
Conditions: This issue occurs when a GUI web browser page is refreshed.
Workaround: There is no workaround.
Symptoms: The GUI "Summary" page does not display dual Supervisor interfaces
correctly. The GUI does not display information on the "Summary" page in the
SUP Input B/W or SUP Input Measurement sections.
Conditions: This issue occurs when redundant Supervisor cards are configured.
Workaround: There is no workaround.
Symptoms: Burst pre-FEC errors are observed on the Cisco RFGW-10 DS-48 line
card.
Conditions: The issue was first observed in Cisco IOS Release 12.2(44)SQ2.
Workaround: There is no workaround.
OL-18677-10
Advertisement
