Advertisement
Caveat
CSCto72423
CSCto88995
CSCtq30229
CSCtq58396
CSCts08763
OL-18677-10
Description
Symptoms: DEPI sessions in learn mode on a missing primary line card fail to get
established after a system reload.
Conditions: This issue occurs when the primary line card is removed during OIR,
and the secondary line card becomes active. After a reload, the DEPI sessions in
learn mode on this primary line card fail.
Workaround: Re-insert the missing primary line card or remove learn mode and
use the cable mode depi remote mode.
Symptoms: The show interfaces transceivers command does not display any value
even when the SFP transceiver modules are connected to the Cisco RFGW-10
Supervisor or the line card.
Conditions: This issue was first observed in Cisco IOS Release 12.2(50)SQ.
Workaround: There is no workaround.
Symptom: Either one of the two TCC cards in slot 13 or slot 14 does not reach the
"Ready" state.
Conditions: This issue occurs when the TCC cards are booted from the Supervisor
in slot 2. If the cards are booted from the Supervisor in slot 1, the cards reach the
"Ready" state.
Workaround: There is no workaround.
Symptoms: DEPI sessions on RF port 12 are not functional.
Conditions: This symptom happens only when QAM or DEPI configuration is
applied after a Supervisor switchover.
Workaround: Reset the primary line card, and the secondary line card, if it is
protected.
Symptoms: The Cisco RFGW-10 monitors both the client and server health status,
instead of only monitoring the client health status.
Conditions: This issue occurs when the DOCSIS Timing Interface (DTI) port on
the Standby Timing, Communication and Control (TCC) card is unplugged from
the server. This also occurs when the TCC card is in a race condition and, the
Standby TCC card that is in a fast or holdover state becomes active.
Workaround: Reset the active TCC card, and make the Standby TCC card in the
normal or free-run state to become active.
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
Caveats
39
Advertisement
