Advertisement
Caveat
CSCty74762
CSCua37072
CSCua85399
CSCua99738
CSCub46796,
CSCud42347
CSCuc34752
OL-18677-10
Description
Symptoms: The line card log may show the following message:
Jul 07 06:23:48
6 10000
set port 0 BW 6, Freq 603000000 Hz
Jul 07 06:23:48
6 10000
UPX freq 500000000 != set freq 603000000
Conditions: This issue occurs randomly on line card when the Supervisor card
performs a bulk configuration to the line card.
Workaround: There is no workaround.
Symptoms: An intrusive carrier is observed on the Cisco RFGW-10 router
affecting cable modems and also the video channels.
Conditions: This issue occurs on the Cisco uBR10-MC3GX60V line card on
Cisco uBR10012 router connected to a Cisco RFGW-10 router with
Cisco RFGW-10 DS48-G1 line card.This issue is not observed on the
Cisco RFGW-10 DS-48 line card.
Workaround: Switch to the protect card and then revert to the working card. If
protect card does not exist, execute the hw-module slot reset command on the
Cisco RFGW-10 DS48-G1 line card. Perform an OIR of the card if needed.
Symptoms: The SNMP query does not get completed when executing the
getmany command for entire MIB tree.
Conditions: This issue occurs while running the getmany command for the entire
MIB tree.
Workaround: There is no workaround.
Symptoms: The show inventory command shows incorrect values for the TCC
hardware revision.
Conditions: This issue occurs under normal conditions.
Workaround: Use the show idprom module command to get the correct values.
Symptoms: The SNMP query does not get completed when executing the
snmpwalk command for entire MIB tree.
Conditions: This issue occurs while running the snmpwalk command for the
entire MIB tree.
Workaround: There is no workaround.
Symptoms: Tracebacks seen on the Cisco RFGW-10 router due to l2tp-class
configuration.
Conditions: This issue occurs when l2tp-class configuration is changed to
depi-class configuration. Stateful switchover is configured on the Cisco
RFGW-10 router.
Workaround: Exit out of l2tp-class configuration using exit command before
configuring depi-class configuration.
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
0 mv_hw_ctrl >> cnfg_rf_freq_pwr_mv():
0 ERROR mv_hw_ctrl, upx_cmd_set_freq():
Caveats
35
Advertisement
