Advertisement
New and Changed Information
The following defines the LEDs, connectors, and switches on the Cisco RFGW-10 Supervisor Engine
V-10GE:
•
•
•
•
•
•
Supported SFP Modules
•
•
•
•
•
RFGW-10 RF Switch Cards
The RF Switch provides RF data path redundancy at both the line card (slot) level and the RF port level
for bidirectional DOCSIS traffic up to 1.2 GHz. Additionally, the RF Switch cards are the coaxial cable
termination point for the Cisco RFGW-10.
Functionally the RFGW-10-RFSW1 card physically switches out a failed line card (port by port) at the
RF data path level. The card is capable of supporting two simultaneous RF line card failures. It is
designed to support dual 1:N redundancy groups (where N is a group of RF line cards associated with a
single protect card).
There are 12 RF Switch cards per chassis, providing 120 RF ports for the system.
The chassis must include all 12 RF Switch cards for proper operation.
Note
Each RF Switch card supports a single Cisco UCH2 connector header; the UCH2 supports 10 MCX
coaxial connections per card. The RF Switch card is physically separate from the RF line card slots
allowing insertion or removal of the RF line cards without disruption of the cable plant wiring.
The RF Switch card is the central hardware component for chassis-level HA features. The card can be
configured and controlled via the system-level CLI functionality. The RF Switch card is a hardware and
firmware-based module (no operating software) that can be field-upgraded via the chassis command line
interface (CLI).
The RF Switch card faceplate includes a single LED. The LED does not indicate a line card failover.
RFGW-10 TCC Cards
The Cisco RFGW-10 UEQAM supports two Timing, Communication, and Control (TCC) slots. The
TCC card acts as a secondary processor that controls the overall system clock generation and
distribution, DOCSIS time-stamp synchronization, and system control of the front panel display (FPD),
and the RF Switch cards.
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
10
Console port
Management port (10/100)
Reset button
Compact flash
Four Ethernet Uplink interfaces
Two 10GE interfaces
SFP-GE-S: 1000BASE-SX short wavelength; with DOM (550 m on MMF)
SFP-GE-L: 1000BASE-LX/LH long wavelength; with DOM (10 km on SMF)
SFP-GE-T: 1000BASE-T SFP (NEBS 3 ESD) (100 m on Cat5 UTP)
X2-10GB-SR: 10GBASE-SR X2 module (26 m on MMF)
X2-10GB-LR: 10GBASE-LR X2 module (10 km on SMF)
OL-18677-10
Advertisement
