Advertisement
Caveat
CSCts25806
CSCts57957
CSCts59691
CSCts61094
CSCtt07863
CSCtt37497
CSCtu16429
OL-18677-10
Description
Symptoms: The output for the show depi session verbose command is the same
when DEPI is enabled or disabled.
Conditions: This issue occurs when show depi session verbose command is
executed.
Workaround: There is no workaround.
Symptom: The Cisco uBR10012 router does not allow DEPI session
reconfiguration on Cisco RFGW-10 QAM interface for 60 seconds after being
triggered.
Conditions: This issue occurs when the DEPI session configuration on the
Cisco uBR10012 router is removed.
Workaround: Wait for 60 seconds for the local end of the DEPI session on
Cisco RFGW-10 router to get removed. Then try to reconfigure.
Symptoms: Traceback observed on Cisco RFGW-10 router while changing the
modulation from Annex B to Annex A on the Cisco uBR10012 router.
Conditions: This issue was observed while changing modulation from Annex B to
Annex A on the Cisco uBR10012 router.
Workaround: There is no workaround.
Symptoms: Memory leak observed on the Cisco RFGW-10 router.
Conditions: This issue occurs after copying the configuration that contains
manual DEPI configuration on the Cisco RFGW-10 router and is connected to
Cisco uBR10-MC3GX60V line card.
Workaround: There is no workaround.
Symptoms: Traceback and error messages are observed on the Cisco RFGW-10
router.
%LCRED-3-LC_CANT_SET_TXRX: Unable to set Active/Standby Tx/Rx
selection for Line Card 11 (idx=11).
Conditions: This issue occurs when the secondary line card has an error condition
such as SerDes failure, S2w failure etc. and is configured as a member of a line
card redundancy (LCRED) group.
Workaround: Replace the secondary line card with a good line card with no failure
condition.
Symptoms: The secondary Supervisor card silently reloads due to parser error.
Conditions: This issue occurs while configuring Video feature on the
Cisco RFGW-10 router.
Workaround: There is no workaround.
Symptoms: Traceback and error messages are observed on the Cisco RFGW-10
router.
*Nov
1 11:44:09.522: %RFGW-3-UNEXPECTED: Error updating state from LC
Conditions: This issue occurs when show cable depi l2tp summary command is
executed on the Cisco RFGW-10.
Workaround: There is no workaround.
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
Caveats
33
Advertisement
