Advertisement
Caveats
Caveat
CSCud07545
CSCud28064
CSCud32457
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
36
Description
Symptoms: The Gigabit Ethernet interfaces goes to admin down state after a
Supervisor card switchover and powering down of the line card.
Conditions: This issue occurs when line card is powered down using the no
hw-module power command and after a Supervisor switchover.
Workaround: Unshut the Gigabit Ethernet interface after powering up the line
card.
Symptoms: The following error message and traceback is observed on the
RFGW-10 console.
.Nov 17 03:30:02.996: %SYS-2-MALLOCFAIL: Memory allocation of 10000
bytes failed from 0x11832D18, alignment 0
Pool: Processor
Free: 640572
Alternate Pool: None
Free: 0
-Process= "SNMP ENGINE", ipl= 0, pid= 350
-Traceback= 10D32524 10D32C70 1181EED0 118213F0 11821700 11832D1C
11833958 11696644 11696844 11691144 116918FC 1094ECF8 1094C6D8
11694628 116693F0 11659D5C
Conditions: This issue occurs when snmpwalk command is run continuously for
9 hours causing memory leak.
Workaround: There is no workaround.
Symptoms: Copying files using secure copy (scp) method on the Cisco RFGW-10
generates errors.
Conditions: This issue occurs while copying files.
Workaround: Copy files as follows:
Router# copy slot0:redirect.out scp://haiwchen@171.70.80.70
Address or name of remote host [171.70.80.70]?
Destination username [haiwchen]?
Destination filename [redirect.out]?
Writing redirect.out
Password:
!!!!!
1137048 bytes copied in 7.604 secs (149533 bytes/sec)
Cause: Memory fragmentation
Cause: No Alternate pool
OL-18677-10
Advertisement
