Download Print this page

Cisco RF Gateway 10 Release Notes page 21

Release notes in ios release 12.2sq
Hide thumbs Also See for RF Gateway 10:

Advertisement

Open Caveats for Cisco IOS Release 12.2(50)SQ6
Caveat
CSCub95597
CSCud02393
CSCud09247
CSCud16912
CSCud19522
CSCud38529
OL-18677-10
Description
Symptoms: Issuing snmpwalk command on "ifName" MIB object
results in a traceback and a spike in CPU utilization.
Conditions: This issue occurs while issuing snmpwalk command
on ifName MIB object.
Workaround: There is no workaround.
Symptoms: DEPI midplane pings failed count counter is
incremented by 1 or n even when a DEPI route exists on the Cisco
RFGW-10 router.
Conditions: This issue occurs when the Cisco RFGW-10 router is
left idle for a long time. The show midplane ping statistics
command displays the failed counter value incremented by 1 or n.
Workaround: Clear the midplane ping statistics and verify the
midplane ping statistics again.
Symptoms: FastEthernet1 port and VLAN interfaces go to down
state after replacing the saved configuration with a running
configuration on the Cisco RFGW-10 router.
Conditions: This issue occurs when the Cisco RFGW-10 is reloaded
and the saved configuration is replaced with the running
configuration.
Workaround: Use the no shut command to unshut the ports.
Symptoms: The compact flash size is displayed incorrectly on
standby Supervisor card.
Conditions: This issue occurs after swapping the compact flashes
between the active and standby Supervisor cards.
Workaround: There is no workaround.
Symptoms: The standby Supervisor card goes to Route Processor
Redundancy (RPR) mode after a switchover.
Conditions: This issue occurs when line cards are removed from a
line card redundancy group configuration, and supervisor
switchover is initiated using the redundancy force-switchover
command on the Cisco RFGW-10 router.
Workaround: There is no workaround.
Symptoms: Data plane DEPI sessions status does not become active
when Cisco RFGW-10 DS48 line card becomes operational after it
is reset.
Conditions: This issue occurs when the stand-alone TCC card reset
without a standby TCC card.
Workaround: Reset the Cisco RFGW-10 DS-48 line card.
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
Caveats
21

Advertisement

loading