Advertisement
Caveats
Caveat
CSCui40108
CSCuh55064
Open Caveats for Cisco IOS Release 12.2(50)SQ5
Caveat
CSCtz57400
CSCua42551,
CSCty27319
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
28
Description
Symptoms: DEPI sessions are not established on the Cisco RFGW-10 when 4
sessions or its multiples are not configured on the QAM interface.
Conditions: This issue occurs when less than 4 sessions or non-multiples of 4
sessions are configured
Workaround: Configure DEPI sessions in multiples of 4.
Symptoms: Front panel LEDs switch off after a TCC card switchover.
Conditions: This issue occurs after the TCC card switchover is performed.
Workaround: Reboot the Cisco RFGW-10 router.
Description
Symptom: Error messages seen on the RFGW-10
and Supervisor V-10GE 10GE
(RFGW-X4516-10GE) line card:
C4K_HWPORTMAN-4-BLOCKEDTXQUEUE
transmit queue HwTxQId3 on Switch Phyport
Te1/1, count=5702344
Conditions: This occurs when Supervisor V-10GE
10GE is running for long time and TenGigabit
interface, where this issue is observed, is unused
and not connected.
Workaround: Fail-over the SUP line card having
the interface.
Symptom: The SNMP query response for
"ifOperStatus" of QAM and QAM-red interfaces
displays their status as "down". The show [ip]
interface command for QAM interfaces displays
line protocol status is "up".
Conditions: Cable-RFGW-10 (MPC8540)
running Cisco IOS Release 12.2SQ and the
following show commands are used to display
interface status:
show ip interface brief
•
show ip interface brief
•
show interface
•
show ip interface
•
Workaround: There is no impact on functionality.
There is no workaround.
Blocked
OL-18677-10
Advertisement
