Parameter Setting - Toshiba B-SX6T SERIES System Mode Manual

2. SYSTEM MODE

2.2 Parameter Setting

Outline of Parameter Setting
In the Parameter Setting mode, various kinds of parameters, such as communication, key, LCD, etc. can be set.
This will allow a use of the printer to comply with your operating conditions.
The Parameter Setting menu contains the following:
<2>PARAMETER SET
[PAUSE]
<2>PARAMETER SET
FONT CODE PC-850
[PAUSE]
<2>PARAMETER SET
ZERO FONT 0
[PAUSE]
<2>PARAMETER SET
SPEED 9600bps
[PAUSE]
<2>PARAMETER SET
DATA LENG. 8bits
[PAUSE]
<2>PARAMETER SET
STOP BIT 1bit
[PAUSE]
<2>PARAMETER SET
PARITY EVEN
[PAUSE]
<2>PARAMETER SET
XON+READY AUTO
[PAUSE]
<2>PARAMETER SET
LCD ENGLISH
[PAUSE]
<2>PARAMETER SET
FORWARD WAIT OFF
[PAUSE]
<2>PARAMETER SET
HEAD UP CUT OFF
[PAUSE]
<2>PARAMETER SET
RBN SAVE ON (TAG)
[PAUSE]
<2>PARAMETER SET
CODE ESC,LF,NUL
[PAUSE]
<2>PARAMETER SET
RIBBON NON TRANS
[PAUSE]
<2>PARAMETER SET
PEEL OFF STS OFF
[PAUSE]
NOTE: Baud rate, Data length, Parity, and Transmission control code should be set to the same values as those of the host
computer. Failure to do this causes improper operation.
Character code selection
Character zero selection
Baud rate selection
Data length selection
Stop bit length selection
Parity selection
Flow control code selection
LCD language selection
Auto forward wait selection
Head up cut selection
Ribbon save function selection
Control code selection
Ribbon type selection
Strip wait status selection
<2>PARAMETER SET
FEED KEY FEED
[PAUSE]
<2>PARAMETER SET
KANJI CODE TYPE1
[PAUSE]
<2>PARAMETER SET
EURO CODE B0
[PAUSE]
<2>PARAMETER SET
AUTO HD CHK OFF
[PAUSE]
<2>PARAMETER SET
ACK/BUSY TYPE1
[PAUSE]
<2>PARAMETER SET
WEB PRINTER OFF
[PAUSE]
<2>PARAMETER SET
SENS POSI CENTER
[PAUSE]
<2>PARAMETER SET
INPUT PRIME OFF
[PAUSE]
<2>PARAMETER SET
EX.I/O TYPE1
[PAUSE]
<2>PARAMETER SET
PLUG & PLAY OFF
[PAUSE]
<2>PARAMETER SET
LBL/RBN END TYPE1
[PAUSE]
<2>PARAMETER SET
PRE PEEL OFF OFF
[PAUSE]
<2>PARAMETER SET
BACK SPEED STD
[PAUSE]
<2>PARAMETER SET
MAXI CODE TYPE1
[PAUSE]
<2>PARAMETER SET
PEEL OFF TRQ R0
[PAUSE]
<2>PARAMETER SET
STABILIZER ON
[PAUSE]
2-18
EO13-33002
2.2 Parameter Setting
Feed key function selection
Kanji code selection
Euro code selection
Auto print head check selection
Centronics ACK/BUSY timing
selection
Web printer function selection
Media sensor selection
Input prime selection
Expansion I/O interface type
selection
Plug & Play selection
Label end/Ribbon end selection
Pre-strip selection
Reverse feed speed selection
Maxi code specification selection
Strip motor torque selection
Stabilizer function selection