2. SYSTEM MODE
2.1.4 Self-Diagnostic Test and Result Print Out
When the Maintenance Counter/Parameter Settings is printed, the message returns to "<1>DIAG. Vx.x".
Press the [PAUSE] key twice.
The Self-Diagnostic Test is ready. Press the [PAUSE] key to start.
<1>DIAG. Vx.x
AUTO DIAGNOSTIC
The printer starts a self-diagnosis, and prints out the result. During printing, the message below appears on
the display.
<1>DIAG. Vx.x
CHECKING & PRINT
After printing is completed, the display returns to "<1>DIAG. Vx.x".
NOTE: If an error occurs, an error message appears, the printer stops printing. After clearing the error, press the
[PAUSE] key to return the display to "<1>DIAG.Vx.x". The printer does not restart printing automatically.
• Print Sample
NOTES: 1. Print conditions: Print speed: 4"/sec., Sensor: No sensor, Printing method:
(*1)
thermal
(*1) Depends on the printing mode setting.
2. Software version No., Part No. of ROM and checksum vary according to the
software version of PROGRAM ROM.
3. The last two digits of the checksum are usually "00".
4. When Kanji ROM is not installed, the checksum becomes "0000".
5. The symbol "°" of "°C" may not be printed depending on the type of character code.
PROGRAM
(1)
MAIN
BOOT
FONT
(2)
KANJI
(3)
EEPROM
(4)
SDRAM
(5)
SENSOR1
(6)
SENSOR2
(7)
PE LV.
(8)
M THRE.
(9)
(10)
EXP.I/O
(11)
EX.232C
(12)
SIO
(13)
STRIP
RFID
(14)
, Media length: 87 mm, Issue mode: Batch printing
B-SX8T
15OCT2005 V1.0A: 1A00
20SEP2005 V1.0: 8500
AD00
GOTHIC :9F00
MINCHO :7400
OK
16MB
00000000, 00000111
[H]23°C [A]22°C
[R]4.2V [T]2.5V
[R]1.2V [T]4.3V
[R]5.0V [T]5.0V
[RANK]1 305DPI
NG
NG
NG NG
NG
OK #00RV972 (EU0)
2-11
EO13-33002
(Revision Date: Jul. 24, 2008)
2.1 Self-diagnostic Test
Thermal transfer/Direct