On Line Mode - Toshiba B-SX6T SERIES System Mode Manual

3. ON LINE MODE

3. ON LINE MODE
In the ON LINE mode, the following settings can be performed.
• Automatic threshold setting for the Feed Gap Sensor
• Automatic threshold setting for the Black Mark Sensor
Reset
•
Parameter settings (Same as Section 2.2.)
•
Printer parameter fine adjustment (Same as Section 2.3.)
•
Dump mode
•
Expansion mode
•
Automatic calibration
•
Enabling/disabling the LAN
•
Real time clock setting
•
This section describes the automatic threshold setting for the feed gap sensor/black mark sensor, reset
operation, dump mode, automatic calibration, LAN setting, and real time clock setting. The procedures of
the parameter setting and printer parameter fine adjustment are described in Section 2.2 and Section 2.3
respectively.
ON LINE
[PAUSE]
PAUSE
Hold down [RESTART] key for 3 sec.
<1>RESET
[FEED]
<2>PARAMETER SET
[FEED]
<3>ADJUST SET
[FEED]
<4>DUMP MODE
[FEED]
<5>EXPAND MODE
[FEED]
<6>AUTO CALIB.
[FEED]
<7>LAN
[FEED]
<8>RTC SET
[FEED]
Hold down [PAUSE]
key for 3 sec.
[PAUSE]
[RESTART]
[PAUSE]
[RESTART]
[PAUSE]
[RESTART]
[PAUSE]
[RESTART]
[PAUSE]
[RESTART]
[PAUSE]
[RESTART]
[PAUSE]
[RESTART]
[PAUSE]
[RESTART]
TRANSMISSIVE
[FEED] or [RESTART]
REFLECTIVE
Reset operation menu
Parameter setting menu (Refer to Section 2.2.)
Printer Parameter fine adjustment menu (Refer to Section 2.3.)
Dump mode menu
BASIC expansion menu
Automatic calibration setting menu
LAN enable/disable setting menu
Real Time Clock setting menu
3- 1
EO13-33002
3. ON LINE MODE
Automatic threshold setting
for the feed gap sensor
Automatic threshold setting
for the black mark sensor