Toshiba B-SX6T SERIES System Mode Manual page 54

2. SYSTEM MODE
How to Enter Test Print Mode
While pressing the [FEED] and [PAUSE] keys at the same time, turn on the printer. Hold both keys until
the "<1>DIAG. Vx.x" Message appears.
<1>DIAG. Vx.x
Press the [FEED] key 3 times.
The Test Print is ready to be performed.
<4>TEST PRINT
NOTES: 1. When pressing the [FEED] and [RESTART] keys at the same time in the Test Print menu, the
message returns to "<4>TEST PRINT".
2. If holding the [FEED] or [RESTART] key for 0.5 seconds or longer in the Test Print menu, the key is
entered continuously.
3. The fine adjustment parameters are effective for the Test Print. (except for X Axis Fine Adjustment.)
4. If any error occurs, an error message appears, and the printer stops printing. After clearing the
errors, press the [PAUSE] key to return to the System Mode menu. The printer does not restart
printing automatically.
5. A changed parameter becomes enabled by pressing the [PAUSE] key.
6. A label size greater than the image buffer length cannot be designated. If designated, the printer
prints in the image buffer, or the printer stops because of an error.
7. The ribbon saving function automatically starts when the space area is as described below if the
ribbon saving function parameter is set to ON and thermal transfer is selected for the printing mode:
• 3"/sec: 20 mm or more
• 4"/sec: 20 mm or more
• 8"/sec: 30 mm or more
8.
9.
Media
T
Ribbon Save Area
E
8 mm
Ribbon Save Area
C
2-48
EO13-33002
2.4 Test Print