Table Of Contents - Toshiba B-SX6T SERIES System Mode Manual

1. INTRODUCTION----------------------------------------------------------------------------------------------------- 1- 1
1.1 Key Operation Flow ----------------------------------------------------------------------------------------------1- 1
1.2 Operation Panel ---------------------------------------------------------------------------------------------------1- 2
2. SYSTEM MODE ----------------------------------------------------------------------------------------------------- 2- 1
2.1 Self-diagnostic Test ----------------------------------------------------------------------------------------------2- 3
2.1.1 Printing Mode Selection ----------------------------------------------------------------------------------------- 2- 4
2.1.2 Dispensing Mode Selection ------------------------------------------------------------------------------------ 2- 4
2.1.3 Maintenance Counter/Parameter Settings Printing Out ------------------------------------------------- 2- 5
2.1.4 Self-Diagnostic Test and Result Print Out ----------------------------------------------------------------- 2-11
2.1.5 Print Head Element Check ------------------------------------------------------------------------------------ 2-17
2.2 Parameter Setting------------------------------------------------------------------------------------------------2-18
2.2.1 Character Code Selection ------------------------------------------------------------------------------------- 2-19
2.2.2 Character Zero Selection -------------------------------------------------------------------------------------- 2-20
2.2.3 Baud Rate Selection -------------------------------------------------------------------------------------------- 2-20
2.2.4 Data Length Selection ------------------------------------------------------------------------------------------ 2-21
2.2.5 Stop Bit Length Selection -------------------------------------------------------------------------------------- 2-21
2.2.6 Parity Selection--------------------------------------------------------------------------------------------------- 2-22
2.2.7 Flow Control Code Selection---------------------------------------------------------------------------------- 2-22
2.2.8 LCD Language Selection -------------------------------------------------------------------------------------- 2-23
2.2.9 Auto Forward Wait Selection---------------------------------------------------------------------------------- 2-23
2.2.10 Head Up Cut Selection ----------------------------------------------------------------------------------------- 2-24
2.2.11 Ribbon Save Function Selection ----------------------------------------------------------------------------- 2-24
2.2.12 Control Code Selection----------------------------------------------------------------------------------------- 2-25
2.2.13 Ribbon Type Selection ----------------------------------------------------------------------------------------- 2-26
2.2.14 Strip Wait Status Selection ------------------------------------------------------------------------------------ 2-26
2.2.15 FEED Key Function Selection -------------------------------------------------------------------------------- 2-27
2.2.16 KANJI Code Selection ------------------------------------------------------------------------------------------ 2-27
2.2.17 EURO Code Selection------------------------------------------------------------------------------------------ 2-27
2.2.18 Auto Print Head Check Selection ---------------------------------------------------------------------------- 2-28
2.2.19 Centronics Interface ACK/BUSY Timing Selection ------------------------------------------------------ 2-28
2.2.20 Web Printer Function Selection ------------------------------------------------------------------------------ 2-29
2.2.21 Media Sensor Selection ---------------------------------------------------------------------------------------- 2-29
2.2.22 Input Prime Selection ------------------------------------------------------------------------------------------- 2-30
2.2.23 Expansion I/O Interface Type Selection-------------------------------------------------------------------- 2-30
2.2.24 Plug & Play Selection ------------------------------------------------------------------------------------------- 2-31
2.2.25 Label End/Ribbon End Selection ---------------------------------------------------------------------------- 2-31
2.2.26 Pre-Strip Selection----------------------------------------------------------------------------------------------- 2-33
2.2.27 Reverse Feed Speed Selection ------------------------------------------------------------------------------ 2-33
2.2.28 Maxi Code Specification Selection -------------------------------------------------------------------------- 2-33
2.2.29 Strip Motor Torque Selection --------------------------------------------------------------------------------- 2-34
2.2.30 Stabilizer Function Selection---------------------------------------------------------------------------------- 2-34

TABLE OF CONTENTS

EO13-33002
(Revision Date: Jul. 24, 2008)
Page