Operation Panel - Toshiba B-SX6T SERIES System Mode Manual

1. INTRODUCTION

1.2 Operation Panel

The figure below illustrates the Operation Panel and key functions.
The LCD Message Display is a 16-character x 2-line display, which shows messages in alphanumeric
characters and symbols to indicate the printer's status. .
There are three LEDs on the Operation Panel.
LED
POWER The printer is turned on.
ON LINE The printer is ready to print.
ERROR The printer is in an error state.
The [FEED], [RESTART] and [PAUSE] keys function as described below.
Feeds or ejects one media.
FEED
Adjusts media to a proper position if the media is not properly positioned by feeding
one or two blank media before printing.
Prints data in the image buffer on one media according to the system mode setting.
In system mode, this key is used to select various parameters or to set a fine
adjustment value in the negative direction (-).
Resumes printing when the printer is in a pause state or an error state.
RESTART
Restores the same state as when the power is turned off and on again.
In system mode, this key is used to select various parameters or to set a fine
adjustment value in the positive direction (+).
Stops printing temporarily.
PAUSE
Programs threshold values.
In system mode, this key is used as an enter key.
POWER LED
(Green)
ERROR LED
(Red)
Illuminates when...
LCD Message
Display
ON LINE LED
(Green)
[FEED] key
[RESTART] key
[PAUSE] key
1- 2
EO13-33002
1.2 Operation Panel