Head Up Cut Selection; Ribbon Save Function Selection - Toshiba B-SX6T SERIES System Mode Manual

2. SYSTEM MODE
NOTES: 1. If the printer is not used for a few days, the top edge of the media may become curly, which may
cause a paper jam. The Auto Forward Wait Function prevents this problem since the media feed
amount is increased so that the media stops past the platen.
2. When the Stop Position Fine Adjustment Value is set in + direction, the media will stop past the
media outlet.
When the value is set in – direction, the media will stop inside the media outlet.
3. This setting will be useful to fine adjust the cut position of labels.

2.2.10 Head Up Cut Selection

This parameter is to choose whether to activate the head up action in the cut issue.
This function prevents ribbon smudges by raising the print head during a reverse feed to the print start
position.
When "<2>PARAMETER SET" appears, press the [PAUSE] key until the following display appears.
<2>PARAMETER SET
HEAD UP CUT OFF
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting the head up action in cut issue, press the [PAUSE] key.
NOTES: 1. For the B-SX6T, this function is available only when an optional ribbon saving module (B-SX908-R-
QM-R) is installed
2. The print head may not be raised depending on the rise of the solenoid's temperature.

2.2.11 Ribbon Save Function Selection

This parameter is to choose whether to activate the Ribbon Saving function or not.
This function enables reducing the ribbon loss caused by taking up unused ribbon during non-print areas.
When "<2>PARAMETER SET" appears, press the [PAUSE] key until the following display appears.
<2>PARAMETER SET
RBN SAVE ON (TAG)
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting the ribbon save function, press the [PAUSE] key.
NOTES: 1. For the B-SX6T, this function is available only when an optional ribbon saving module (B-SX908-R-
QM-R) is installed.
2. If this parameter is set to ON without installing a ribbon saving module, the ribbon will be slack
during paper feed or printing, and as a result, printing cannot be performed properly.
Also, be sure to conform the choice to the actual head lever position. Failure to do this may disable
proper ribbon saving function.
HEAD UP CUT ON
HEAD UP CUT OFF
RBN SAVE ON (TAG)
RBN SAVE ON (LBL)
RBN SAVE OFF
Activated
Not activated
Activated (When the head lever is set to position 2.)
Activated (When the head lever is set to position 1.)
Not activated
2-24
EO13-33002
2.2 Parameter Setting