Toshiba B-SX6T SERIES System Mode Manual page 56

2. SYSTEM MODE
Sensor Type Selection
Select a sensor type among "TRANS" (Feed Gap Sensor), "REFLECT" (Black Mark Sensor) and
"NONE".
<4>TEST PRINT
SENSOR TRANS.
[RESTART]
[FEED]
After selecting a sensor type, press the [PAUSE] key to go to Printing Mode Selection.
NOTE: Select a sensor type which is proper for the media being used. Basically, the Reflective Sensor
(Black Mark Sensor) is for tag paper, and the Transmissive Sensor (Feed Gap Sensor) is for label.
Printing Mode Selection
Select a printing mode for the test print among "TRANSFR" (Thermal transfer: transparent ribbon),
"NO TRAN" (Thermal transfer: non transparent ribbon), and "DIRECT" (Thermal direct).
<4>TEST PRINT
PRT TYPE TRANSFR
[RESTART]
[FEED]
After selecting a printing mode, press the [PAUSE] key to go to Issue Mode Selection.
NOTE: Select a printing mode which is proper for the operating conditions. Basically, the Thermal
Transfer is for the use of ribbon, and the Thermal Direct is for the use of thermal paper.
Issue Mode Selection
Select an issue mode for the test print among "[S]NO CUT" (Batch mode without cut), "[C]WITH CUT"
(Cut mode), and "[H]PEEL OFF" (Strip mode).
<4>TEST PRINT
TYPE[S]NO CUT
[RESTART]
[FEED]
After selecting an Issue Mode, press the [PAUSE] key to go to Media Length Setting.
NOTE: Cut mode is available only when the optional cutter module (B-SX208-QM-R) is installed. Strip
mode is available only when the optional strip module (B-SX908-H-QM-R) is installed.
SENSOR NONE
SENSOR REFLECT.
SENSOR TRANS.
PRT TYPE TRANSFR
PRT TYPE NO TRAN
PRT TYPE DIRECT
TYPE[S]NO CUT
TYPE[C]WITH CUT
TYPE[H]PEEL OFF
None
Black Mark Sensor
Feed Gap Sensor
Thermal Transfer: Transparent ribbon
Thermal Transfer: Non transparent ribbon
Thermal Direct
Batch mode without cut
Cut mode
Strip mode
2-50
EO13-33002
2.4 Test Print