Using The Usb Cable Strain Relief; Setting Up Network Options (If Applicable); Setting Up A Wifi Option - Toshiba 1TN Quick Installation Manual

If a WiFi or Ethernet option is installed:
You might need a USB cable to set up your printer (see "Setting up a WiFi option" on
page 16 or "Setting up an Ethernet option" on page 18).

Using the USB cable strain relief

A cable strain relief
cable can be routed around this cable strain relief to prevent the cable from being accidentally
unplugged.
Figure 7. USB cable strain relief (6145-1TN)

Setting up network options (if applicable)

If you have a WiFi or Ethernet option card installed, you might need to reconfigure your
printer's setup to connect to the network. See "Setting up a WiFi option" on page 16 or "Setting
up an Ethernet option" on page 18 for instructions on setting up your network.

Setting up a WiFi option

The WiFi option for the Toshiba TCx Single Station printer can be used as a network client or as
an access point. When using the WiFi option as a client, the printer connects to an existing WiFi
network. When using the WiFi option as an access point, the number of clients should be limited
to no more than two.
You can set up the WiFi option (connecting the client to a network or configuring the access
point) using one of the following options:
• "Setting up WiFi using a WiFi connection" on page 16
• "Setting up WiFi with a USB connection" on page 17
After completing setup, the printer will be accessible via the applicable network. Additional
configuration or setup changes can be accomplished via that network.
Setting up WiFi using a WiFi connection
To set up the WiFi option using a WiFi connection, complete the following steps.
1. Using the Toshiba 6145 printer offline functions (see Firmware offline tests and the Test/
Status Receipt), select the Network Configuration AP Mode option, and then the Select
Access Point Mode option. A random password will be generated and printed.
2. Save the random password that is generated and printed when you select AP mode. You
will use this password to connect to the printer network.
3. After the printer reboots, print a Test/Status receipt (see the Note in Step 11. The Test/Status
receipt contains the information you need to connect to the printer network (or Printer AP).
16
TCx Single Station Printer Installation and Service Guide
is attached to the back of the Toshiba TCx Single Station Printer. The USB
A