Toshiba B-SX6T SERIES System Mode Manual page 3

2.3 Printer Parameter Fine Adjustment ----------------------------------------------------------------- 2-35
2.3.1 Feed Amount Fine Adjustment ------------------------------------------------------------------------------- 2-37
2.3.2 Cut/Strip Position Fine Adjustment -------------------------------------------------------------------------- 2-38
2.3.3 Reverse Feed Amount Fine Adjustment ------------------------------------------------------------------- 2-41
2.3.4 X Coordinate Fine Adjustment-------------------------------------------------------------------------------- 2-42
2.3.5 Print Tone Fine Adjustment (Thermal Transfer/Thermal Direct Print) ------------------------------ 2-44
2.3.6 Ribbon Motor Voltage Fine Adjustment (Feed/Take-up Motor) -------------------------------------- 2-45
2.3.7 Threshold Manual Fine Adjustment (Black Mark/Feed Gap Sensor) ------------------------------- 2-46
2.4 Test Print------------------------------------------------------------------------------------------------------------2-47
2.4.1 Specifying the Print Condition for the Test Print --------------------------------------------------------- 2-49
2.4.2 Test Print Pattern Selection ----------------------------------------------------------------------------------- 2-52
2.4.3 Slant Line (1 dot)------------------------------------------------------------------------------------------------- 2-53
2.4.4 Slant Line (3 dots) ----------------------------------------------------------------------------------------------- 2-54
2.4.5 Characters--------------------------------------------------------------------------------------------------------- 2-55
2.4.6 Barcode ------------------------------------------------------------------------------------------------------------ 2-55
2.4.7 Non-Printing------------------------------------------------------------------------------------------------------- 2-56
2.4.8 Factory Test------------------------------------------------------------------------------------------------------- 2-56
2.4.9 Auto Print ---------------------------------------------------------------------------------------------------------- 2-57
2.5 Sensor Adjustment ----------------------------------------------------------------------------------------------2-58
2.5.1 Sensor Status Display ------------------------------------------------------------------------------------------ 2-59
2.5.2 Black Mark Sensor Adjustment------------------------------------------------------------------------------- 2-59
2.5.3 Feed Gap Sensor Adjustment -------------------------------------------------------------------------------- 2-60
2.5.4 Black Mark Sensor and Feed Gap Sensor Adjustment (Paper End Level)------------------------ 2-60
2.6 RAM Clear ----------------------------------------------------------------------------------------------------------2-61
2.6.1 RAM Clear Menu Selection ----------------------------------------------------------------------------------- 2-62
2.6.2 No RAM Clear ---------------------------------------------------------------------------------------------------- 2-62
2.6.3 Maintenance Counter Clear ----------------------------------------------------------------------------------- 2-62
2.6.4 Printer Parameter Clear ---------------------------------------------------------------------------------------- 2-63
2.7 IP Address Setting-----------------------------------------------------------------------------------------------2-66
2.7.1 Printer IP Address, Gateway IP Address, and Subnet Mask Settings ------------------------------ 2-67
2.7.2 Socket Port Setting ---------------------------------------------------------------------------------------------- 2-68
2.7.3 DHCP and DHCP ID Settings -------------------------------------------------------------------------------- 2-68
2.7.4 DHCP Host Name Setting ------------------------------------------------------------------------------------- 2-69
2.8 BASIC Setting -----------------------------------------------------------------------------------------------------2-70
2.8.1 Basic Specification Selection Mode ------------------------------------------------------------------------- 2-71
2.8.2 Basic File Browser----------------------------------------------------------------------------------------------- 2-71
2.8.3 Basic Trace Selection Mode ---------------------------------------------------------------------------------- 2-71
2.8.4 Basic Expansion Mode (Execution of Basic Program)-------------------------------------------------- 2-72
2.9 RFID Module Setting --------------------------------------------------------------------------------------------2-73
2.9.1 RFID Read Test -------------------------------------------------------------------------------------------------- 2-74
2.9.2 RFID Module Type Selection --------------------------------------------------------------------------------- 2-75
2.9.3 RFID Tag Type Selection -------------------------------------------------------------------------------------- 2-76
2.9.4 RFID Error Tag Delection-------------------------------------------------------------------------------------- 2-76
2.9.5 Maximum Number of RFID Issue Retries------------------------------------------------------------------ 2-77
2.9.6 Maximum Number of RFID Read Retries------------------------------------------------------------------ 2-78
2.9.7 RFID Read Retry Time-out ------------------------------------------------------------------------------------ 2-79
EO13-33002
(Revision Date: Jul 24, 2008)
Page