Setup; Firmware Download - Toshiba B-SX6T SERIES System Mode Manual

4. PROGRAM DOWN LOAD

4.2.2 Setup

Setup Disk
Make sure that you have all two diskettes available of the "B-SA series Download Program".
Installation Procedure
(1) While running Windows 98, Windows 2000, or Windows XP, insert Setup Disk (1/2) into the PC
floppy drive.
(2) Click on the START button then highlight RUN and click on RUN.
(3) When the RUN display appears, type in A:\SETUP and click on OK.
(4) Install the Download Program by following the messages on the display.

4.3 Firmware Download

If it ever becomes necessary to upgrade the firmware in the printer you will be supplied with a floppy disk
containing the latest firmware revision similar to that shown below.
The following paragraphs give the download procedure that the firmware (Boot program, Application
program and Character generator) is copied onto the PC hard disk before being transferred to the printer.
Before starting the download procedure
• Copy the firmware program contained in the FDKs to your specified directory of the hard disk. If the file
format of the file installed into the FDK is "*.EXE", click it twice to decompress into "*.ROM" file.
• Connect the printer to your PC with the Centronics I/F cable or the RS-232C I/F cable. For the
Centronics communication, if the printer port has been allocated to LPT 1, change to another one
temporarily. Failure to do this will disable you from firmware download.
Firmware FDK (Main)
B-SA4T Series
FIRMWARE(MAIN)V1.0
WR. FD-SA-FIRM-MAIN
MAIN:SA4T-MAIN-20050515.EXE
(SX4-MAIN-20050515.ROM)
7FM01217000:D700
15th May 2005
V001.000
Copyright© 2005
TOSHIBA TEC CORPORATION
All Rights Reserved
4- 2
4.3 Firmware Download
Firmware FDK (Boot/CG)
B-SA4T Series
FIRMWARE(BOOT/CG)V1.0
WR. FD-SA-FIRM-BOOT
BOOT:B-SA4T-BOOT-20050515.ROM
7FM01218000:8B00
C/G :B-SA4T-CG-20050515.ROM
7FM01218000:AE00
15th May 2005
V001.000
Copyright© 2005
TOSHIBA TEC CORPORATION
All Rights Reserved
EO13-33002