Toshiba B-SX6T SERIES System Mode Manual page 15

2. SYSTEM MODE
Item #
RIBBON (32) Ribbon type selection
PEEL OFF STATUS (33) Strip wait status selection
FEED KEY (34) Feed key function
KANJI (35) Kanji code type (Not supported by QM model)
EURO CODE (36) Euro font code
AUTO HD CHK (37) Auto print head broken element check
ACK/BUSY (38) Centronics interface ACK/BUSY timing setting
WEB PRINTER (39) Web printer function
SENS POSI (40) Media sensor
INPUT PRIME (41) Input prime selection
EX. I/O MODE (42) Expansion I/O interface operating mode
PLUG&PLAY (43) Plug & Play setting
LBL/RBN END (44) Print processing setting at the label/ribbon error detection TYP1:
PRE PEEL OFF (45) Pre-Strip setting
BACK SPEED (46) Reverse Feed Speed setting
MAXI CODE SPEC. (47) MAXI code specification selection
PEEL OFF TRQ (48) Strip motor torque
STABILIZER (49) Stabilizer function
AUTO CALB. (50) Automatic calibration
LAN (51) Enabling or disabling the LAN
PRTR IP ADDRESS (52) Printer IP address
GATE IP ADDRESS (53) Gateway IP address
SUBNET MASK (54) Subnet mask
MAC ADDRESS (55) MAC (Media Access Control) address for LAN controller
TTF AREA (56) True type font registration area size
EXT CHR AREA (57) External character registration area size
BASIC AREA (58) BASIC file store area size
PC SAVE (59) PC saving area size
SOCKET PORT (60) Socket port number
Description
(Reset operation when INIT signal is ON)
on the MAIN PC Board
TRANS: Transparent ribbon
NON TRANS: Non transparent ribbon
ON: Available
OFF: Unavailable
FEED: Feeds one label
PRINT: Prints image buffer on one label
TYPE 1: Windows code
TYPE 2: Original code
20H to FFH
ON: Available
OFF: Unavailable
TYPE1: A rise of ACK signal and a release
TYPE2: A fall of ACK signal and a release
ON: Available
OFF: Unavailable
CENTER: Fixed sensor
EDGE: Movable sensor
ON: Available
OFF: Unavailable
TYPE1: Standard mode
TYPE2: Inline mode
ON: Available
OFF: Unavailable
TYP2:
OFF: Unavailable
STD: 3"/second
LOW: 2"/second
TYPE1:
TYPE2:
R0: Standard
ON:
OFF: Stabilizer function is not used.
OFF: Disabled
ON TRANS: Enabled with the transmissive
ON REFLECT: Enabled with the reflective
ON SNMP ON:
ON SNMP OFF: LAN Enabled
OFF:
***.***.***.***
***.***.***.***
***.***.***.***
0 KB to 3072 KB (unit of 128 KB)
0 KB to 3072 KB (unit of 128 KB)
0 KB to 1792 KB (unit of 128 KB)
0 KB to 3072 KB (unit of 128 KB)
ON: Available
OFF: Unavailable
Port No. 0 to 65535
2- 9
(Revision Date: Mar. 26, 2009)
2.1 Self-diagnostic Test
Specification
of BUSY occur at the same time.
of BUSY occur at the same time.
Printing is paused in the middle of
printing.
Printing is paused after the label is
issued.
Compatible with the current
version
Special specification
Stabilizer function is used.
sensor
sensor
LAN Enabled
SNMP Enabled
SNMP Disabled
LAN Disabled
- - - - -
EO13-33002