Supported Mibs - Cisco IPS 7.1 Installation Manual

Supported MIBs

Virtualization has the following traffic capture requirements:
•
•
The following sensors support virtualization:
•
•
•
•
•
•
•
•
Supported MIBs
To avoid problems with configuring SNMP, be aware of the MIBs that are supported on the sensor.
The following private MIBs are supported on the sensor:
•
•
•
You can obtain these private Cisco MIBs under the heading SNMP v2 MIBs at this URL:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
MIB II is available on the sensor, but we do not support it. We know that some elements are not correct
Note
(for example, the packet counts from the IF MIB on the sensing interfaces). While you can use elements
from MIB II, we do not guarantee that they all provide correct information. We fully support the other
listed MIBs and their output is correct.
CISCO-PROCESS-MIB is available on the sensor, but we do not support it. We know that some elements
Note
are not available. While you can use elements from CISCO-PROCESS-MIB, we do not guarantee that
they all provide correct information. We fully support the other listed MIBs and their output is correct.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
E-18
The virtual sensor must receive traffic that has 802.1q headers (other than traffic on the native VLAN
of the capture port).
The sensor must see both directions of traffic in the same VLAN group in the same virtual sensor
for any given sensor.
ASA 5500 AIP SSM
ASA 5500-X IPS SSP
ASA 5585-X IPS SSP
IPS 4270-20
IPS 4345
IPS 4360
IPS 4510
IPS 4520
CISCO-CIDS-MIB
The CISCO-CIDS-MIB has been updated to include SNMP health data in IPS 7.1(3)E4 and later.
CISCO-ENHANCED-MEMPOOL-MIB
CISCO-ENTITY-ALARM-MIB
Appendix E Troubleshooting
OL-24002-01