Installing The Slide Rail Kit Hardware - Cisco IPS 7.1 Installation Manual

Installing the Slide Rail Kit Hardware

Step 3 Install the new fan module by aligning it with the fan module bay and pushing it into place until it is
seated.
1
3
Tighten the captive screws.
Step 4
Verify that the fan indicator on the lower right-hand of the back panel is green.
Step 5
Installing the Slide Rail Kit Hardware
Before installing the appliance in the slide rail kit, you must install the slide rail kit hardware.
To install the slide rail kit hardware on the IPS 4510 and IPS 4520, follow these steps:
Power off the appliance.
Step 1
Remove the power cable from the appliance.
Step 2
If your appliance has the fixed cable management brackets, do the following:
Step 3
a.
b.
c.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
7-20
2
10 0-2 40
15 .0/ 8.0
56 /60 Hz
3
Fan module and fan handle
Power supply module
Remove the cable management brackets from the front sides of the appliance.
Remove the appliance from the rack.
Remove the front brackets, left and right side brackets, and left and right rear brackets from the
appliance.
Ci sc o AS
A 12 00 W
AC
C is co -A
C is co -A
S A -F A
S A -F A
V
.A
1
2 Fan module screw
Chapter 7 Installing the IPS 4510 and IPS 4520
N
N
2
OL-24002-01