Cisco IPS 7.1 Installation Manual page 237

Appendix A Logging In to the Sensor
For More Information
For the procedure for initializing the ASA 5585-X IPS SSP using the setup command, see
Setup for the ASA 5585-X IPS SSP, page
Logging In to the Sensor
After you have initialized the sensor using the setup command and enabled Telnet, you can use SSH or
Note
Telnet to log in to the sensor.
To log in to the sensor using Telnet or SSH, follow these steps:
To log in to the sensor over the network using SSH or Telnet.
Step 1
ssh sensor_ip_address
telnet sensor_ip_address
Enter your username and password at the login prompt.
Step 2
login: ******
Password: ******
***NOTICE***
This product contains cryptographic features and is subject to United States and local
country laws governing import, export, transfer and use. Delivery of Cisco cryptographic
products does not imply third-party authority to import, export, distribute or use
encryption. Importers, exporters, distributors and users are responsible for compliance
with U.S. and local country laws. By using this product you agree to comply with
applicable law s and regulations. If you are unable to comply with U.S. and local laws,
return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to export@cisco.com.
***LICENSE NOTICE***
There is no license key installed on the system.
Please go to http://www.cisco.com/go/license to obtain a new license or install a license.
sensor#
OL-24002-01
B-21.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
Logging In to the Sensor
Advanced
A-7