Cisco IPS 7.1 Installation Manual page 250

Advanced Setup
vlan2 300
exit
exit
exit
physical-interfaces GigabitEthernet0/1
admin-state enabled
exit
physical-interfaces GigabitEthernet0/2
admin-state enabled
exit
physical-interfaces GigabitEthernet0/0
admin-state enabled
exit
inline-interfaces newPair
description Created via setup by user asmith
interface1 GigabitEthernet0/1
interface2 GigabitEthernet0/2
exit
exit
service analysis-engine
virtual-sensor newVs
description Created via setup by user cisco
signature-definition newSig
event-action-rules rules0
anomaly-detection
anomaly-detection-name ad0
operational-mode inactive
exit
physical-interface GigabitEthernet0/0
exit
virtual-sensor vs0
physical-interface GigabitEthernet0/0 subinterface-number 1
logical-interface newPair
service event-action-rules rules0
overrides deny-packet-inline
override-item-status Disabled
risk-rating-range 90-100
exit
exit
[0] Go to the command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration and exit setup.
Enter
Step 28
Enter your selection[2]: 2
Configuration Saved.
Reboot the appliance.
Step 29
sensor# reset
Warning: Executing this command will stop all applications and reboot the node.
Continue with reset? []:
Enter
Step 30
Apply the most recent service pack and signature update. You are now ready to configure your appliance
Step 31
for intrusion prevention.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
B-12
to save the configuration.
2
to continue the reboot.
yes
Appendix B Initializing the Sensor
OL-24002-01