Removing And Installing The Ac Power Supply - Cisco IPS 7.1 Installation Manual

Removing and Installing the Power Supply
Table 6-4
Indicator Color and State
Blinking amber, at the rate of one
blink per second
Off

Removing and Installing the AC Power Supply

If you remove a power supply, replace it immediately to prevent disruption of service.
Caution
If the appliance is subjected to environmental overheating, it shuts down and you must manually power
Caution
cycle it to turn it on again.
This unit has more than one power supply connection; all connections must be removed completely
Warning
to completely remove power from the unit. Statement 102
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
Warning
the protective device is rated not greater than: 120 VAC, 20A U.S. (240 VAC, 10A international).
Statement 1005
This procedure applies only to the appliances with a removable AC power supply (IPS 4360).
Note
If only one power supply is installed, make sure that it is installed in slot 0 (left slot) and that slot 1 (right
Note
slot) is covered with a slot cover.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
6-18
AC and DC Power Supply Indicator
Description
A power supply warning event has occurred, but the power
supply can continue to operate. The warning event can be
temperature, voltage, current, or fan operating outside the
normal operating range.
The power supply is shut down.
Chapter 6 Installing the IPS 4345 and IPS 4360
OL-24002-01