Cisco IPS 7.1 Installation Manual page 411

Appendix E Troubleshooting
State
BlockEnable = true
NetDevice
NetDevice
NetDevice
NetDevice
NetDevice
BlockedAddr
sensor#
OL-24002-01
IP = 192.0.2.1
NATAddr = 0.0.0.0
Communications = telnet
BlockInterface
InterfaceName = 502
InterfacePreBlock = Pre_Acl_Test
BlockInterface
InterfaceName = 507
InterfacePostBlock = Post_Acl_Test
IP = 192.0.2.3
AclSupport = Does not use ACLs
Version = 6.3
State = Active
Firewall-type = PIX
IP = 192.0.2.7
AclSupport = Does not use ACLs
Version = 7.0
State = Active
Firewall-type = ASA
IP = 102.0.2.8
AclSupport = Does not use ACLs
Version = 2.2
State = Active
Firewall-type = FWSM
IP = 192.0.2.9
AclSupport = uses Named ACLs
Version = 12.2
State = Active
IP = 192.0.2.10
AclSupport = Uses VACLs
Version = 8.4
State = Active
Host
IP = 203.0.113.1
Vlan =
ActualIp =
BlockMinutes =
Host
IP = 203.0.113.2
Vlan =
ActualIp =
BlockMinutes =
Host
IP = 203.0.113.4
Vlan =
ActualIp =
BlockMinutes = 60
MinutesRemaining = 24
Network
IP = 203.0.113.9
Mask = 255.255.0.0
BlockMinutes =
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
Gathering Information
E-99